Staple Troubleshooting Guide

Your Price: Call for pricing

Item Number: stapletrouble

Manufacturer: American Printing

Staple	Problem	Reason	Remedy
	Right Leg Short	Cutter not properly adjusted in relation to swivel	Shorten Left leg & make same length as right leg
	Corner Buckled	Chipped or broken driver	Check driver ends for signs of damage; reverse or replace driver
	Bent Crown	Wrong size wire Supporter retracts too easily	Check wire size for job Check tension of supporter spring, increase tension or replace spring
	Left Leg Missing	Wire Slipping in grip	Clean grip. If worn, reverse grip in holder, or replace
	Comes Out in Pieces	Swivel sticking Corner of swivel too sharp	Clean and lubricate swivel Check swivel, if corner over which wire is formed is too sharp, stone corner slightly
	Corner Rounded	Worn swivel	Replace swivel
	Left Leg Short	Clogged or worn grip Left leg feed not adjusted properly	Clean grip. Check for worn teeth/reverse or replace grip Adjust length of leg
	Legs Buckled	Wrong size wire Dull wire cutters	Check wire size for job being stitched Check wire cutters; reverse or replace wire cutters
	Partially Formed	Worn driver bar latch	Replace latch
	Right Leg Missing	Corner of swivel too sharp	Check swivel; if corner over which wire is formed is too sharp, stone corner slightly
	Corner Broken / Cut Through	Wire too hard Corner of swivel too sharp	Check wire being used Check swivel; if corner over which wire is formed is too sharp, stone corner slightly
	Legs Contracted	Worn wire cutters Wire straighteners are not properly adjusted	Check, reverse or replace cutters Check setting of wire straighteners
	Loose Clinch	Wrong setting of stitcher adjustement for thickness of work / clinchers set too low	Check setting of stitcher for thickness of work, and raise clincher
	Legs Spread	Worn wire cutters Wire straighteners not properly adjusted Worn bender bar	Check, reverse or replace cutters Check setting of wire cutters Check and replace bender bar
	Crown Buckled	Wrong setting of stitcher adjustment for thickness or work	Check setting and adjust for thickness of work